Xerox WorkCentre 5790 Series Service Manual page 362

Figure 2 Circuit diagram
Status Indicator RAPs
11-100-110, 11-110-110
11-110-110 Sheet Late to Hole Punch RAP
11-110-110 Sheet late at the punch sensor.
Initial Actions
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP
death or injury. Moving parts can cause injury.
Check the following:
• The 2K LCSS PWB DIP switch settings, refer to
tings RAP.
• Ensure the paper tray guides are set to the correct position for the size of paper in the
tray.
• For a paper jam at the entrance to the 2K LCSS. Check that there is no obstruction that
would prevent a sheet from arriving in position for punching, refer to the
Damage in the 2K LCSS RAP.
• The punch sensor, Q11-110 for chad debris,
Procedure
NOTE: In diagnostics, actuating any 2K LCSS sensor or switch can change the displayed state
on the UI. Make sure that the correct sensor or switch is tested.
Figure 1. Enter dC330, code 11-110. Actuate the punch sensor, Q11-110. The
changes.
Y N
Go to Flag 1. Check Q11-110.
Refer to:
• 11G-110 2K LCSS PWB Damage RAP.
• GP 11, How to Check a Sensor.
• P/J307, 2K LCSS PWB.
• 11D-110 2K LCSS Power Distribution RAP
Repair or install new components as necessary:
• Punch sensor, PL 11.6 Item
• 2K LCSS PWB, PL 11.26 Item
Perform SCP 6 Final Actions.
May 2013
2-330
WARNING
14. Disconnect the power cord. Electricity can cause
11F-110 2K LCSS PWB DIP Switch Set-
Figure 1.
7.
1.
Xerox® WorkCentre® 5790 Family
11H-110 Copy
display