Replacement Of Carriage Assembly Drive Belts - Kodak X-Omat MULTILOADER 300 Plus Service Manual

Hide thumbs Also See for X-Omat MULTILOADER 300 Plus:
Table of Contents

Advertisement

SM 3058-6
FUNCTION TEST
1
.
Check that the FILM PICK UP MOTOR M6 is running.
Start the SERVICE PROGRAM
Select SERVICE MODE from the GLOBAL MENU ....................................... press ENTER
ENTER SERVICE MODE MESSAGE IS DISPLAYED.......................................... press ENTER
UNIT DATA are displayed ................................................................................ press ENTER
Select COMPONENT TEST ................................................................................ press ENTER
Select CASSETTE MOTORS ............................................................................... press ENTER
Select FILM PICK UP M6................................................................................... press ENTER
Select forward ................................................................................................... press ENTER
Select backward ............................................................................................... press ENTER
2
.
Exit the SERVICE PROGRAM
Press 3 times BACKSPACE
Select LEAVE COMPONENT TEST ................................................................... press ENTER
Select Quit ML300 SERVICE MODE ............................................................... press ENTER
Select Quit the program ................................................................................. press ENTER.

REPLACEMENT OF CARRIAGE ASSEMBLY DRIVE BELTS

Note
Replace both Drive Belts at the same time.
1
.
Do PROCEDURE "REMOVAL OF CONVEYOR".
2
.
Do PROCEDURE "REPLACEMENT OF FILM PICK UP MOTOR" step 1 to 3.
3
.
Mark the position of the BELT-LINKS on the MECHANISM PLATES. These marks
are used as a reference when installing the new DRIVE BELTS.
4
.
Remove the IDLER ROLLERS.
5
.
Remove the small C-RINGS at the BELT LINKS.
6
.
Slide the GEAR to the right and remove the DOWEL PIN.
7
.
Slide the FILM PICK UP DRIVE SHAFT to the left.
9/98
2-52
REPLACEMENTS
KODAK AG, Stuttgart

Advertisement

Table of Contents
loading

This manual is also suitable for:

X-omat multiloader 300

Table of Contents