Kodak X-Omat MULTILOADER 300 Plus Service Manual page 198

SM 3058-6
The STIFFENERS make the FILM POCKET more stable and the additional ROLLERS avoid
error M-A6. With the previous design it was possible that the fresh FILM from the MAGAZINE
hit against the first ROLLER and was stripped off from the FILM POCKET SUCKER BAR
when it was transported into the FILM POCKET. The EDGE PROTECTORS installed with
modification 30 are no longer necessary. The material of the inner ROLLERS is not changed.
It is still coated FOAM RUBBER. At the outer ROLLERS O-RINGS are used instead.
Two TORSION SPRINGS in the FILM POCKET are replaced with TENSION SPRINGS. The
new design allows replacement of these SPRINGS to be made in a few minutes without
disturbing the FILM POCKET adjustment.
9/98
TORSION SPRINGS
up to SN 2000
figure 7-9
7-8
ML300 SN > 2000
KODAK AG, Stuttgart