Start The Service Program Select Service Mode From The Global Menu; Enter Service Mode Message Is Displayed - Kodak X-Omat MULTILOADER 300 Plus Service Manual

SM 3058-6
30.
Open the SET SCREW of the right hand TIMING DISK.
31.
Turn the SUCKER BAR ARM backward by hand until there is no clearance.
32.
Rotate the right hand TIMING DISK in the direction of the arrow until SENSOR
B58/M_PU_ER is interrupted (on). This is indicated by a BEEP from the SENSOR TEST.
33.
Tighten the SET SCREW.
34.
Check that the FILM POCKET SUCKER BAR reaches the REAR POSITION without
bouncing.
Press BACKSPACE twice to come back to the screen COMPONENT TEST
Select MAGAZINE MOTORS ............................................................................ press ENTER
Select FILM PICK UP MAGAZINE M15 ........................................................... press ENTER
Select FORWARD
Select BACKWARD
35.
Run a few cycles; if the FILM does not interfere with parts of the CASSETTE
TRANSPORT MODULE, proceed with step 36, else proceed with step 29.
36.
Do the adjustments of the MAGAZINE SUCKERS and the FILM POCKET BLOW
PIPES.
37.
Move the FILM POCKET to MAGAZINE LEVEL 3
Start the SERVICE PROGRAM
Select SERVICE MODE from the GLOBAL MENU ....................................... press ENTER
ENTER SERVICE MODE MESSAGE is displayed............................................ press ENTER
9/98
figure 3-41
3-44
ADJUSTMENTS
KODAK AG, Stuttgart