SM 3058-6
6
.
Take out the DRIVE PULLEY with the DOWEL PIN.
7
.
Take off the C-RING of the BALL BEARING.
8
.
Take off the BALL BEARING.
9
.
Lift the ROLLER END with the PLASTIC BEARING and pull out the TRANSPORT
ROLLER.
Note
Make sure that all PLASTIC BEARINGS are installed as shown in the figure below.
10
. Install the new TRANSPORT ROLLER.
FUNCTION TEST
1
.
Check that a CASSETTE is transported correctly forward and backward.
9/98
This side of all PLASTIC BEAR-
figure 2-5
2-6
REPLACEMENTS
INGS must show up
KODAK AG, Stuttgart