Kodak X-Omat MULTILOADER 300 Plus Service Manual page 69

REPLACEMENTS
5
. If you have a XML300 without the additional SENSOR MOUNTING BRACKET
proceed with step 6. Otherwise proceed with step 9.
6
. Make the front of the SENSOR MOUNTING CLIPS (B19) 0.8 to 1mm smaller and
mount it into the CARRIAGE ASSEMBLY. See the drawing on the previous page.
7
. Move the SENSOR B19 forward in direction of the CASSETTE as far as possible
and fix it in this position with glue.
8
. Proceed with step 10.
9
. Install the new SENSOR into the SENSOR MOUNTING BRACKET.
10.
Fix the harness with WIRE TIES. Use the marks from step 4 as reference.
FUNCTION TEST
1
. Switch on the ML300.
2
. Test the function of SENSOR B19 with the SENSOR TEST.
Start the SERVICE PROGRAM.
Select SERVICE MODE from the GLOBAL MENU ....................................... press ENTER
ENTER SERVICE MODE MESSAGE is displayed............................................ press ENTER
UNIT DATA are displayed ................................................................................ press ENTER
Select COMPONENT TEST ................................................................................ press ENTER
Select SENSORS .................................................................................................. press ENTER
Select WITH/WITHOUT SOUND ........................................................................ press ENTER
3
. Manually tilt the CASSETTE SUCKER BAR. B19 must now be indicated ON.
4
. Exit the SERVICE PROGRAM.
Press 3 time BACKSPACE
Select LEAVE COMPONENT TEST ................................................................... press ENTER
Select QUIT ML300 SERVICE MODE ............................................................... press ENTER
Select Quit the program ................................................................................. press ENTER.
KODAK AG, Stuttgart 2-57
SM 3058-6
9/98