Kodak X-Omat MULTILOADER 300 Plus Service Manual page 51

REPLACEMENTS
Note
It is not necessary to unhook the REJECTER SPRING (SPRING between REJECTER and
PCB A5).
6
. Loosen the SPRING HOOK NUTS on the right-hand REJECTER, so that the
REJECTER can be shifted a few millimetres to the right.
7
. Shift the CLUTCH DISK 2 to the right. If necessary push the STOP PLATE a little
forward. Do not loosen the STOP PLATE. This would alter the end positions of
the REJECTER.
8
. Take out the old CLUTCH SPRING.
9
. Install the new SPRING.
10
. Shift CLUTCH DISK 2 fully to the left. Ensure that CLUTCH DISK 1 is engaged
with the FILM POCKET ARM.
11
. Move the COLLAR fully to the left and tighten its SET SCREW.
12
. Tighten the SPRING HOOK NUTS on the right-hand REJECTER.
13
. Rotate in the FILM CHUTE and fix it with the 6 MOUNTING SCREWS
(or 1 for SN > 3000) from step 3.
14
. Mount the REAR PANEL
FUNCTION TEST
1
. Switch on the ML300.
2
. Run a few cycles with different film sizes to check for correct operation.
KODAK AG, Stuttgart 2-39
SM 3058-6
9/98