Parameter; Introduction; How To Set A Parameter - Kodak X-Omat MULTILOADER 300 Plus Service Manual

PARAMETER

4. PARAMETER

INTRODUCTION

The purpose of the PARAMETERS is to optimise the function of the ML300. There are 2
types of PARAMETERS. The value of the first type ends with an H (for example 18H) and
the second type ends with a D (for example 15D). The H means this is a hexa-decimal value.
The D means this is a decimal value. Only the PARAMETERS with hexa-decimal value can
be altered just by keying in a new value. The 3 PARAMETERS with decimal values can only
be altered by starting a special option.
For the hexa-decimal PARAMETERS an allowed range exists.
For example LOWER POCKET:
This means every value between 0h and 64h can be used. It does not mean that with every
value the ML300 works best. In general the ML300 works best with the DEFAULT (or
STANDARD) setting. If a value outside the range is used and ENTER is pressed, the
displayed value will default automatically to the DEFAULT VALUE.
The range is different for every PARAMETER.

HOW TO SET A PARAMETER

In this section it is explained with every PARAMETER, how to use the CES SERVICE
SOFTWARE. The first line tells always what should be performed. In the next lines it is
explained how to reach this goal. These additional explanations are printed italic and can be
skipped if you are experienced with the CES SERVICE SOFTWARE.
EXAMPLE:
1
. Change PARAMETER XYZ
Start the SERVICE PROGRAM
Select SERVICE MODE from the GLOBAL MENU ....................................... press ENTER
ENTER SERVICE MODE MESSAGE is displayed............................................ press ENTER
UNIT DATA are displayed ................................................................................ press ENTER
Select CHANGE ML300 DATA from the MAIN MENU ............................... press ENTER
Select CHANGE PARAMETER .......................................................................... press ENTER
Select PARAMETER XYZ
Key in the new value....................................................................................... press ENTER
KODAK AG, Stuttgart
PARAMETER CHANGE WITH OPTION
CASSETTE-OFFSET
MAGAZINE LEVEL
HOME POSITION
GEAR BACKLASH
NEARLY EMPTY NEARLY EMPTY
RANGE 0h....64h
DEFAULT 40h
CASSETTE-LENGTH
SCAN RUN
SCAN RUN
SCAN RUN
4-1
SM 3058-6
9/98