Kodak X-Omat MULTILOADER 300 Plus Service Manual page 129

ADJUSTMENTS
Note
If the CASSETTE LEVEL is too high the FILM POCKET SUCKER BAR ARM touches the
CENTRE ROLLER of the bottom TRANSPORT ROLLER in the CONVEYOR.
90.
SENSOR B32/M_PO_PL MAGAZINE LEVEL must be actuated before SENSOR
B31/M_PO_ES END SWITCH.
Disconnect CONNECTOR A4X17. This allows you to move the FILM POCKET
manually up and down.
Start the SERVICE PROGRAM
Select SERVICE MODE from the GLOBAL MENU ....................................... press ENTER
ENTER SERVICE MODE MESSAGE is displayed............................................ press ENTER
UNIT DATA are displayed ................................................................................ press ENTER
Select COMPONENT TEST from the MAIN MENU ....................................... press ENTER
Select SENSORS .................................................................................................. press ENTER
Select SENSOR TEST WITH SOUND.................................................................. press ENTER
91.
Connect CONNECTOR A4X17.
92.
Do a SCAN RUN.
Press 3 times BACKSPACE
Select LEAVE COMPONENT TEST .................................................................. press ENTER
Select CHANGE ML300 DATA......................................................................... press ENTER
Select CHANGE PARAMETER ......................................................................... press ENTER
Select SCAN RUN .............................................................................................. press ENTER
Select NEARLY EMPTY ....................................................................................... press ENTER
Select STORE PARAMETERS ............................................................................ press ENTER
Select RETURN TO MAIN MENU ...................................................................... press ENTER
Select COMPONENT TEST ................................................................................ press ENTER
Select MAGAZINE MOTORS ............................................................................ press ENTER
93.
If Step 89 was not correct go back to step 87 else proceed with step 94.
94.
Exit the SERVICE PROGRAM.
Press 3 times BACKSPACE
Select LEAVE COMPONENT TEST ................................................................... press ENTER
Select QUIT ML300 SERVICE MODE ............................................................... press ENTER
Select Quit the program ................................................................................. press ENTER
KODAK AG, Stuttgart 3-59
SM 3058-6
9/98