Replacement Of The Sensor Sucker Bar Tilt B19 - Kodak X-Omat MULTILOADER 300 Plus Service Manual

SM 3058-6
2
. Exit the SERVICE PROGRAM
Press 3 times BACKSPACE
Select LEAVE COMPONENT TEST ................................................................... press ENTER
Select QUIT ML300 SERVICE MODE ............................................................... press ENTER
Select Quit the program ................................................................................. press ENTER.

REPLACEMENT OF THE SENSOR SUCKER BAR TILT B19

1
. Switch off the ML300.
2
. Take off the TOP COVER, the REAR and the RIGHT-HAND PANEL.
3
. Manually move the CASSETTE SUCKER BAR to the front.
4
. Take out SENSOR B19. Mark the position of the WIRE TIES.
SENSOR B19
This SENSOR MOUNTING BRACKET is
used in XML300 with SN > 1260
9/98
For XML300 without the additional SEN-
SOR MOUNTING BRACKET. Make the
front of the MOUNTING CLIPS
0.8 to 1.0 mm shorter, as indicated
by the dark area. Use a file for it.
figure 2-54
2-56
REPLACEMENTS
KODAK AG, Stuttgart