Improved Film Pocket - Kodak X-Omat MULTILOADER 300 Plus Service Manual

ML300 SN > 2000

IMPROVED FILM POCKET

The position of the BLOW PIPES is altered by 0.5 mm. To avoid a new adjustment procedure
tool TL-4582 became 0.5 mm thicker. Discard your old tool and order a new one. The altered
BLOW PIPE POSITION results in a different setting of the PARAMETER ADDITIONAL
STEPS. It is now 05h.
Note
·
The default value of the PARAMETER ADDITIONAL STEPS is still set to 0Ah in the
SERVICE SOFTWARE. It will be corrected when there is a new SERVICE SOFTWARE
RELEASE in the future.
·
Two STIFFENERS and additional ROLLERS are added to the FILM POCKET.
The outer side of the FILM POCKET has now more
ROLLERS. The inner ROLLERS are FOAM
RUBBER and the outer ROLLERS are just O-RINGS
STIFFENER
KODAK AG, Stuttgart
figure 7-8
7-7
STIFFENER
SM 3058-6
9/98