Kodak X-Omat MULTILOADER 300 Plus Service Manual page 23

REPLACEMENTS
10
. Lift out the short TRANSPORT ROLLER near to the ODOMETER.
short TRANSPORT
ROLLER
11
. Shift both CASSETTE TIMING BELT SHAFTS to the left.
12
. Replace the TIMING BELT.
13
. When installing the HOLDING FINGER, make sure that the TIMING BELT is
centred before you tighten the MOUNTING SCREWS.
14.
The ODOMETER (PCB A10) has to be positioned as shown.
KODAK AG, Stuttgart
ODOMETER
figure 2-13
CODE DISC
PCB A10
1.2 mm max. for new style PCBs
0.5 mm max. for old style PCBs
0.1 mm min. for both styles.
figure 2-14
2-11
On this side of the CODE DISC
is an imprinted number
21.3 ± 0.5 mm
This corner is cut at an angle
SM 3058-6
9/98