Kodak X-Omat MULTILOADER 300 Plus Service Manual page 81

ADJUSTMENTS
STOP BOLT for CASSETTE OPENER
STOP BOLT for CASSETTE OPENER
DOWN
10
. Tighten the MOUNTING SCREWS of the STOP PLATE.
11.
Check the position of the STOP PLATE.
-Disconnect SENSOR B15(CONNECTOR X9)
-Select UP. The MOTOR M5 must turn for a short distance and is stopped then
( A high pitched tone can be heard at the same time.)
-Connect SENSOR B15.
-Select DOWN until the CASSETTE OPENER stops in its bottom position.
-Manually actuate SENSOR B15. Do not break its thin PLASTIC ACTUATOR.
-Select DOWN again. MOTOR M5 should turn for a short distance and is
stopped then. A high pitched tone can be heard at the same time.
-Select UP until the CASSETTE OPENER stops in its uppermost position.
If the UP and DOWN positions are correct proceed with step 12. Otherwise reposition
the STOP PLATE and repeat step 11.
KODAK AG, Stuttgart
UP
Position of the STOP PIN when
the CASSETTE OPENER is up
Position of the STOP PIN when
the CASSETTE OPENER is down
figure 3-10
3-11
SM 3058-6
9/98