Double Sheet Sensor Sn > 3000 - Kodak X-Omat MULTILOADER 300 Plus Service Manual

ADJUSTMENTS
1
. Start the SENSOR TEST.
Start the SERVICE PROGRAM
Select SERVICE MODE from the GLOBAL MENU ....................................... press ENTER
ENTER SERVICE MODE MESSAGE is displayed............................................ press ENTER
UNIT DATA are displayed ................................................................................ press ENTER
Select COMPONENT TEST from the MAIN MENU ....................................... press ENTER
Select SENSORS .................................................................................................. press ENTER
Select SENSOR TEST WITH SOUND.................................................................. press ENTER
2
. Loosen the 2 MOUNTING SCREWS Of the DOUBLE SHEET SENSOR B59/M_PU_DS.
3
. Put FEELER GAUGE 0.3mm ( 0.012inches ) between the DETECTOR ROLLERS.
4
. Move the DOUBLE SHEET SENSOR until it is activated.
5
. Fasten the MOUNTING SCREWS.
6
. Check with GAUGE LEAVE 0.25mm ( 0.01inches ) that the DOUBLE SHEET
SENSOR is not actuated.
7
. If necessary repeat step 3, 4 ,5 and 6.
8
. Exit the SERVICE MODE.
Press 3 times BACKSPACE
Select LEAVE COMPONENT TEST ................................................................... press ENTER
Select QUIT ML300 SERVICE MODE ............................................................... press ENTER
Select Quit the program ................................................................................. press ENTER
DOUBLE SHEET SENSOR SN > 3000
Note
Starting with SN > 3000 the DOUBLE SHEET DETECTOR can discriminate between:
This discrimination is accomplished by a change in the mechanics and by the OPERATING
SOFTWARE >= 3.31.
FUNCTIONAL DESCRIPTION
If there are 2 or more FILMS between the DETECTOR ROLLERS the path of light in
SENSOR B59 is interrupted by AREA 2 of the DOUBLE SHEET SENSOR ARM.
KODAK AG, Stuttgart
no FILM
1 FILM
2 or more FILMS
3-63
SM 3058-6
9/98