Adjustment Sensor B25 / B26 Ml300 Plus - Kodak X-Omat MULTILOADER 300 Plus Service Manual

SM 3058-6

ADJUSTMENT SENSOR B25 / B26 ML300 Plus

PURPOSE:
The ENTRANCE ROLLERS of the integrated 3000RA Processor do not detect the LEADING
EDGE of the FILM transported from the ML300 Plus to the PROCESSOR. The FILM
DETECTOR SENSORS are now part of the ML300 Plus PROCESSOR INTERFACE.
FILM DETECTOR B25 (right) is connected to A8X32 and FILM DETECTOR B26(left) is
connected to A8X24.
To handle the 2 SENSORS a new OPERATING SOFTWARE is required.
It will be version 5.14 or higher.
1
. Switch off the ML300 Plus.
2
. Take off the REAR PANEL.
3
. Take out the PROCESSOR INTERFACE from the ML300 Plus and place it on a safe
surface.
4
. Switch on the ML300 Plus.
5
. Connect the LAP TOP COMPUTER to the ML300 Plus and start the SERVICE
SOFTWARE.
Note
With SERVICE SOFTWARE 3.30 SENSORS B25/26 are not displayed. However you will hear
the BEEP when one of these SENSORS changes its status.
6
. Select the SENSOR TEST with SOUND.
7
. Turn the EXIT ROLLERS for a complete revolution with no FILM in between.
There must be no signal from the SENSOR TEST. This test is most important to avoid
false film detection. If SENSOR B25 or B26 changes its status, loosen its MOUNTING
SCREWS and move the SENSOR up or down as required. Fasten the MOUNTING
SCREWS and repeat step 7.
8
. Insert a piece of film 10 cm (4 in.) wide in the centre between the 2 EXIT ROLLERS.
See the drawing on the next page.
9
. Turn the EXIT ROLLERS for a complete revolution with the FILM in between. There
must be a signal from the SENSOR TEST. It does not matter if the signal is interrupted
during the revolution. The OPERATING SOFTWARE takes care of this.
9/98 3-92
ADJUSTMENTS
KODAK AG, Stuttgart