Kodak X-Omat MULTILOADER 300 Plus Service Manual page 213

ML300 SN > 3000
HUMIDIFIER
An in-built HUMIDIFIER is available as Modification 42 Type 1 SELECTIVE. It can be
installed into all ML300s. ML300s with serial numbers > 3000 are already prepared in the
factory. This means the HARNESS, TWIN WATER VALVE and T-FITTING are installed to
ease the installation of the HUMIDIFIER.
The HUMIDIFIER CARTRIDGE cannot be replaced by the CUSTOMER. To replace it the
left-hand SIDE PANEL must be removed.
!
Caution
To replace the HUMIDIFIER CARTRIDGE take off the left-hand SIDE PANEL. Carefully lift
the CARTRIDGE out - it is soaked with water - and remove it in the direction of the FRONT
PANEL. Water from the soaked CARTRIDGE must not drop into the ELECTRONICS.
Note
The HUMIDIFIER CARTRIDGE must be replaced at regular intervals
- at least 2 times a year - to minimise biological growth.
PROTECTIVE COVER
This COVER protects the FITTINGS at the rear of the ML300, in case a CASSETTE falls
behind the ML300. See the figure on the next page. This PROTECTIVE COVER is available
as Modification 44 for ML300s with serial numbers < 3000.
KODAK AG, Stuttgart
figure 8-5
8-5
SM 3058-6
HUMIDIFIER
9/98