Kodak X-Omat MULTILOADER 300 Plus Service Manual page 41

REPLACEMENTS
Note
Take care of the DOWEL PIN it may fall down.
6
. Take off the C-RING and take out the SPROCKET.
7
. Take out the STEPPER MOTOR MOUNTING SCREWS.
8
. Install new the STEPPER MOTOR.
9
. Move the STEPPER MOTOR up to tension the CHAIN.
10.
Tighten the MOUNTING SCREWS.
FUNCTION TEST
1
. To test the function of the FILM POCKET STEPPER MOTOR do a SCAN RUN.
Start the SERVICE PROGRAM.
Select SERVICE MODE from the GLOBAL MENU ....................................... press ENTER
ENTER SERVICE MODE MESSAGE is displayed............................................ press ENTER
UNIT DATA are displayed ................................................................................ press ENTER
Select CHANGE ML300 DATA from the MAIN MENU ............................... press ENTER
Select CHANGE PARAMETER .......................................................................... press ENTER
Select SCAN RUN .............................................................................................. press ENTER
Select STORE PARAMETERS ............................................................................. press ENTER
2
. Exit the SERVICE PROGRAM
Press BACKSPACE twice
Select QUIT ML300 SERVICE MODE ............................................................... press ENTER
Select Quit the program ................................................................................. press ENTER
KODAK AG, Stuttgart 2-29
SM 3058-6
9/98