Kodak X-Omat MULTILOADER 300 Plus Service Manual page 112

SM 3058-6
20.
Rotate the LEFT HAND TIMING DISK in the direction of the arrow (fig. 36) until
the SENSOR B56/M_PU_EF is interrupted (on).
MAGAZINE
SIDE
21.
Tighten the SET SCREW.
22.
Check that the FILM POCKET SUCKER BAR reaches the FRONT POSITION
without bouncing.
Press BACKSPACE twice to come back to the screen COMPONENT TEST
Select MAGAZINE MOTORS ............................................................................ press ENTER
Select FILM PICK UP MAGAZINE M15 ........................................................... press ENTER
Select BACKWARD
Select FORWARD
23.
If the BALL BEARING is not fully engaged in the DETENT or if the FILM POCKET
SUCKER BAR does not stop without bouncing go back to step 20 else proceed with
step 27.
24.
Exit the SERVICE MODE.
Press 3 times BACKSPACE
Select LEAVE COMPONENT TEST ................................................................... press ENTER
Select QUIT ML300 SERVICE MODE ............................................................... press ENTER
Select Quit the program ................................................................................. press ENTER
25.
Insert a MAGAZINE loaded with 35x43 TEST FILMS into the XML 300.
26.
Run a few cycles; if the FILM does not interfere with parts of the CASSETTE
TRANSPORT MODULE, proceed with step 36, else proceed with step 27.
9/98
figure 3-39
3-42
ADJUSTMENTS
CHUTE SIDE
KODAK AG, Stuttgart