Film Pocket; How To Clean The Suckers; Film Pocket Chain - Kodak X-Omat MULTILOADER 300 Plus Service Manual

ADJUSTMENTS

FILM POCKET

HOW TO CLEAN THE SUCKERS

The main cause of SUCKER MARKS is contamination of the sucker surface. This
contamination can be any number of substances ranging from natural body oil, sweat or even
KODAK Intensifying Screen Cleaner and anti static Solution (which has sometimes been
recommended for cleaning SUCKERS!). Do not use KODAK Intensifying Screen Cleaner and
Anti Static Solution to clean the SUCKERS!
Note
This procedure should be followed if the SUCKERS are touched or if new ones are fitted.
1
. Abrade the surface of the SUCKER carefully using Emery Cloth grade 400 or a
similar material.
2
. Lightly coat the SUCKER with NATURAL (un-perfumed) talcum powder, available
from chemists and pharmacies.

FILM POCKET CHAIN

Prerequisites:
When doing this adjustment, the unit must be levelled.
Purpose:
This adjustment ensures that there is no offset between the left and the right CHAIN and that
the FILM POCKET DRIVE SHAFT is parallel to the BASE PLATE of the MAGAZINE
CHAMBER.
Note
After you did this adjustment, check the adjustment of the FILM POCKET
1
. Switch off the ML300.
2
. Take off the PANELS.
3
. Rotate out the FILM CHUTE.
4
. Take out all MAGAZINES.
5
. Disconnect the STEPPER MOTOR M10 Connector A4X17.
6
. Manually move FILM POCKET to a position so that the top surface of one of the
counterweights is level with the top edge of the GUIDE RAIL.
KODAK AG, Stuttgart 3-35
SM 3058-6
9/98