Kodak X-Omat MULTILOADER 300 Plus Service Manual page 80

SM 3058-6
6
. Adjust the ACTUATOR of SENSOR B15/C_OP_EO CASSETTE OPENER END
SWITCH OPEN as required.
7
. Move the CASSETTE OPENER fully down.
Select DOWN
Proceed with step 4.
8
. Fasten the ACTUATOR MOUNTING SCREW.
Note
It is not possible to see the gap of 1mm. You have to set it by feeling.
9
. With the OPENER still in the upper position, turn the STOP PLATE counter-clockwise
until the STOP BOLT touches the STOP PIN of the DRIVE GEAR. Turn the STOP
PLATE clockwise until there is a gap of approximately 1mm between the STOP PIN and
the STOP BOLT.
9/98
ACTUATOR of SENSOR B15
ACTUATOR MOUNTING SCREW
figure 3-9
3-10
SENSOR B15
KODAK AG, Stuttgart
ADJUSTMENTS