Drive Belt Tension - Kodak X-Omat MULTILOADER 300 Plus Service Manual

SM 3058-6
5
. Set the JUMPER of A8X50 to the MIDDLE POSITION (pin 2-5). This is the position
for normal operation.
6
. Exit the the SERVICE PROGRAM.
Press 3 times BACKSPACE
Select LEAVE COMPONENT TEST ................................................................... press ENTER
Select QUIT ML300 SERVICE MODE ............................................................... press ENTER
Select Quit the program ................................................................................. press ENTER
7
. Run several cycles with all types of CUSTOMER FILMS to ensure correct operation.

DRIVE BELT TENSION

Purpose:
This adjustment ensures that the CASSETTE is correctly transported in and out.
1
. Fix the REAR BELT TENSIONER in its uppermost position.
2
. Move the FRONT BELT TENSIONER up or down, so that the left-hand and the
right-hand BELTS are tensioned equally.
BELT TENSIONER REAR
9/98
figure 3-32
3-34
ADJUSTMENTS
BELT TENSIONER FRONT
KODAK AG, Stuttgart