Kodak X-Omat MULTILOADER 300 Plus Service Manual page 36

SM 3058-6
5
. Install the new CASSETTE OPENER SOLENOID.
6
. Adjust the CASSETTE OPENER SOLENOID.
Start the SERVICE PROGRAM
Select SERVICE MODE from the GLOBAL MENU .................................... press ENTER
ENTER SERVICE MODE MESSAGE is displayed............................................ press ENTER
UNIT DATA are displayed ................................................................................ press ENTER
Select COMPONENT TEST from the MAIN MENU ....................................... press ENTER
Select SOLENOIDS ............................................................................................. press ENTER
Select CASSETTE OPENER Y4........................................................................... press ENTER
Select SOLENOID ON
7
. If the OPENER SHOVEL is only just touching the OPENER PLATE, proceed with
step 9, else proceed with step 8.
Do not turn the SOLENOID too far, the BLOCK LEVER may slide under the LEVER STOP.
See the drawing on the next page.
8
. Loosen the NUTS and turn the OPENER SOLENOID Y4 until the OPENER SHOVEL
is just touching the OPENER PLATE. Tighten the NUTS.
9/98
figure 2-25
2-24
REPLACEMENTS
NUTS
touching slightly
OPENER
PLATE
OPENER SHOVEL
KODAK AG, Stuttgart