Stepper Motor Processor Interface M13/M_Pi - Kodak X-Omat MULTILOADER 300 Plus Service Manual

SM 3058-6

STEPPER MOTOR PROCESSOR INTERFACE M13/M_PI

PURPOSE:
To adjust the phase current of M13 to the correct value. If this current is too low M13 will not
run correctly. If this current is too high the POWER AMPLIFIERS U43 and U44 on CIRCUIT
BOARD A4 sheet 4 will become overloaded.
1
. Start STEPPER MOTOR PROCESSOR INTERFACE.
Start the SERVICE PROGRAM
Select SERVICE MODE from the GLOBAL MENU ....................................... press ENTER
ENTER SERVICE MODE MESSAGE is displayed............................................ press ENTER
UNIT DATA are displayed ................................................................................ press ENTER
Select COMPONENT TEST from the MAIN MENU ....................................... press ENTER
Select INTERFACE/FILM MOT. ......................................................................... press ENTER
Select MAGAZINE ROLLER MOTOR M13 ...................................................... press ENTER
Select MOTOR ON
3
. Connect the GROUND LEAD of the DVM to TP 11 GND PE on CIRCUIT BOARD
A4 sheet 9.
4
. Connect the POSITIVE LEAD of the DVM to TP 14 on CIRCUIT BOARD A4 sheet 4.
9/98
figure 3-75
3-86
ADJUSTMENTS
KODAK AG, Stuttgart