Magazine Levels - Kodak X-Omat MULTILOADER 300 Plus Service Manual

ADJUSTMENTS
6
. Close the FILM CHUTE and tighten the LOCK NUT.
7
. Mount the REAR PANEL.
8
. Run a few cycles with various cassette sizes to ensure proper operation.

MAGAZINE LEVELS

PURPOSE:
This adjustment makes sure that the FILM POCKET SUCKER BAR rotates freely into the
MAGAZINES and into the CASSETTE. UPPER/LOWER LIMIT can be adjusted too.
Note
This adjustment is just a starting point. After it is performed the FILM POCKET
ADJUSTMENT must be checked and if necessary the position of the MAGAZINE LEVEL
BRACKET and the CASSETTE LEVEL BRACKET must be changed.
1
. Loosen the MOUNTING SCREWS of the MAGAZINE LEVEL BRACKET.
2 Set the edge of MAGAZINE LEVEL 3 to a distance of 117.9 ±0.5 mm to the BASE
.
PLATE.
3
. Fasten the MOUNTING SCREWS.
4
. Loosen the MOUNTING SCREWS of the CASSETTE LEVEL BRACKET.
5 Set the edge of CASSETTE LEVEL to a distance of 452.1 ±0.3 mm from the BASE
.
PLATE.
6
. Fasten the MOUNTING SCREWS.
7
. Loosen the MOUNTING SCREWS of the UPPER LIMIT BRACKET.
Note
The UPPER LIMIT BRACKET has to be below the CASSETTE LEVEL BRACKET.
8 Set the edge of UPPER LIMIT to a distance of 446.1 ±0.5 mm from the BASE
.
PLATE.
9
. Fasten the MOUNTING SCREWS.
10.
Loosen the MOUNTING SCREWS of the LOWER LIMIT BRACKET.
KODAK AG, Stuttgart 3-69
SM 3058-6
9/98