Kodak X-Omat MULTILOADER 300 Plus Service Manual page 34

SM 3058-6
28.
The ACTUATOR must now be set to a position that the CASSETTE OPENER
MOTOR is switched off as soon as the OPENER BRACKET is vertical.
Select DOWN until the OPENER is fully down
Select UP until the OPENER stops
29.
If the OPENER BRACKET is vertical proceed with step 30. If not proceed here.
Reposition the ACTUATOR as required and proceed with step 28.
30.
SENSOR B15 is now adjusted correctly. The next step is to adjust the OPENER
STOP PLATE.
Note
It is not possible to see this gap. You have to set it by feeling.
31.
The OPENER is still in the upper position. Turn the STOP PLATE
counter-clockwise until the STOP BOLT touches the STOP PIN of the DRIVE GEAR.
Turn the STOP PLATE clockwise until there is a gap of approximately 1mm between
the STOP PIN and the STOP BOLT.
32.
Tighten the MOUNTING SCREWS of the STOP PLATE.
33.
Check the position of the STOP PLATE.
-Disconnect SENSOR B15(CONNECTOR X9)
-Select UP. The MOTOR M5 must turn for a short distance and is stopped then.
A high pitched tone can be heard at the same time.
-Connect SENSOR B15.
-Select DOWN until the CASSETTE OPENER stops in its bottom position.
-Manually actuate SENSOR B15. Do not break its thin PLASTIC ACTUATOR.
-Select DOWN again. MOTOR M5 should turn for a short distance and is
stopped then. A high pitched tone can be heard at the same time.
-Select UP until the CASSETTE OPENER stops in its uppermost position.
If the UP and DOWN positions are correct, proceed with step 34. Otherwise
reposition the STOP PLATE and repeat step 33.
34.
Exit the SERVICE MODE.
Press 3 times BACKSPACE
Select LEAVE THE COMPONENT TEST .......................................................... press ENTER
Select QUIT ML300 SERVICE MODE ............................................................... press ENTER
Select Quit the program ................................................................................. press ENTER
9/98 2-22
REPLACEMENTS
KODAK AG, Stuttgart