ML300 SN > 2000
NEW CASSETTE TRANSPORT ROLLERS
To improve the CASSETTE TRANSPORT and the CASSETTE CENTRING new CASSETTE
TRANSPORT ROLLERS are used. In addition 2 sets of the ROLLERS are lowered by
1.5 mm to the centre.
!
Caution
The ROLLERS must not be cleaned with alcohol. This would dissolve the coated surface.
Clean them with water only.
At the CASSETTE END STOP is a small BRACKET which prevents lifting of the CASSETTE
when the CASSETTE OPENER ASSEMBLY opens the CASSETTE and moves up.
The shaft of ROLLERS 3 and 4 have a small CENTRING HOLE for identification
ROLLERS 1, 2, 5 and 6 are FOAM RUBBER ROLLERS. ROLLERS 3 and 4 are RUBBER ROLLERS
KODAK AG, Stuttgart
These 4 BEARINGS are 1.5 mm deeper than the others.
figure 7-6
7-5
SM 3058-6
This small
BRACKET holds
down the CAS-
SETTE
9/98