Kodak X-Omat MULTILOADER 300 Plus Service Manual page 30

SM 3058-6
14.
Insert and fasten SCREW 1 to 5.
15.
Insert the 3 MOTOR MOUNTING SCREWS. Do not fasten them. Mount SENSOR
B15/C_OP_EO.
16.
Mount the OPENER STOP PLATE. Use the marks made in step 5 as reference.
Tighten the MOUNTING SCREWS just a bit, that the STOP PLATE can still be moved.
Warning
BE CAREFUL WHEN WORKING IN THE CASSETTE OPENER AREA. THE OPENER MOTOR
AND THE OPENER MECHANISM ARE VERY STRONG. THEY CANNOT BE MOVED
MANUALLY. THEY MAY SQUEEZE YOUR HAND AND TRAP YOU IF YOU TRY TO STOP
THEM MANUALLY. NEVER START THE CASSETTE OPENER MOTOR WHEN SOMEONE'S
HANDS ARE IN THE CASSETTE AREA.
17.
Switch on the ML300
DOWEL PIN should be
in a horizontal position
18.
To mount the MOTOR DRIVE GEAR the DOWEL PIN has to be in the correct
position in relation to the STOP BOLTS of the STOP PLATE.
To rotate the MOTOR SHAFT use the SERVICE PROGRAM. Switch on the CASSETTE
OPENER MOTOR M5 until the DOWEL PIN is in a horizontal position.
9/98
DOWEL PIN GROOVE
figure 2-19
2-18
REPLACEMENTS
KODAK AG, Stuttgart