Magazine Empty Sensor; Start The Service Program Select Service Mode From The Global Menu; Enter Service Mode Message Is Displayed; Unit Data Are Displayed - Kodak X-Omat MULTILOADER 300 Plus Service Manual

SM 3058-6
95.
Do a FUNCTION TEST
96.
Enable the CONTINUOS LOOP MODE.
Move SWITCH S1-1 on PCB A1 to the ON (up) position.
Select FUNC at the OPERATORS DISPLAY
Select SYSTEM at the OPERATORS DISPLAY
Select CONTIN at the OPERATORS DISPLAY
Select CLEAR at the OPERATORS DISPLAY
97.
Insert a MAGAZINE loaded with TEST FILMS.(use small and large film sizes)
98.
Run approximately 30 cycles.
99.
Watch the various movements of the FILM POCKET.

MAGAZINE EMPTY SENSOR

PURPOSE:
This adjustment makes sure that a MAGAZINE is recognised as being empty after the last
FILM is removed.
1
. Insert an empty MAGAZINE into position 1.
2
. Open the MAGAZINE and rotate the FILM POCKET SUCKER BAR fully in.
Start the SERVICE PROGRAM
Select SERVICE MODE from the GLOBAL MENU ....................................... press ENTER
ENTER SERVICE MODE MESSAGE is displayed............................................ press ENTER
UNIT DATA are displayed ................................................................................ press ENTER
Select COMPONENT TEST from the MAIN MENU ....................................... press ENTER
Select MAGAZINE MOTORS ............................................................................ press ENTER
Select STEPPER MOTOR FILM POCKET M10 ................................................. press ENTER
Select MOVE TO LEVELS/HOME POSITION .................................................. press ENTER
Select MOVE TO MAGAZINE 1
Press BACKSPACE twice to come back to screen TEST MAGAZINE MOTORS
Select MAGAZINE OPENING M14 .................................................................. press ENTER
Select FORWARD
Press BACKSPACE
Select FILM PICK UP MAGAZINE M15 ........................................................... press ENTER
Select FORWARD
9/98 3-60
ADJUSTMENTS
KODAK AG, Stuttgart