Kodak X-Omat MULTILOADER 300 Plus Service Manual page 31

REPLACEMENTS
Select SERVICE MODE from the GLOBAL MENU ....................................... press ENTER
ENTER SERVICE MODE MESSAGE is displayed............................................ press ENTER
UNIT DATA are displayed ................................................................................ press ENTER
Select COMPONENT TEST from the MAIN MENU ....................................... press ENTER
Select CASSETTE MOTORS ............................................................................... press ENTER
Select CASSETTE OPENING M5....................................................................... press ENTER
Select DOWN or UP until the DOWEL PIN is in a horizontal position.
Note
The STOP PIN of the DRIVE GEAR has to be to the left of the bottom STOP BOLT. If it is to
the right, the CASSETTE OPENER cannot move for the correct distance.
19.
Mount the DRIVE GEAR onto the MOTOR SHAFT. Ensure that it is seated properly
on the DOWEL PIN. Mount the ACTUATOR removed in step 3 to hold the DRIVE GEAR
on the SHAFT. Do not tighten the ACTUATOR SCREW at this time.
OPENER STOP PLATE
20.
To mount the CHAIN is the next step. To do this the CASSETTE OPENER
MECHANISM and the MOTOR DRIVE GEAR have to be in the correct position.
a. The CASSETTE OPENER MECHANISM must be in its bottom position.
b. The STOP PIN of the DRIVE GEAR should just touch the bottom STOP BOLT of
the STOP PLATE.
Select DOWN until the STOP PIN just touches the STOP BOLT.
KODAK AG, Stuttgart
DRIVE GEAR
STOP PIN
figure 2-20
2-19
SM 3058-6
bottom STOP BOLT
9/98