Disassembly Of The Conveyor - Kodak X-Omat MULTILOADER 300 Plus Service Manual

REPLACEMENTS
8
. Lift out the CONVEYOR.
FUNCTION TEST
1
. Check that the CONVEYOR is seated properly. It must be as far as possible to the
front (e.g. to the INPUT FLAP).
2
. Check that the HOSE is connected again and that it is routed through the CABLE
DUCT.
3
. Check that the HARNESS is fixed with a WIRE TIE at the correct place. Use the
mark from step 4 as reference.
4
. Check that CONNECTORS X55 and X60 are seated properly.
5
. Run TEST CYCLES with different film sizes and check that the FILM is picked up
from the CASSETTE.
6
. Check that the FILM is transported correctly into the FILM CHUTE.

DISASSEMBLY OF THE CONVEYOR

Disassembly of the CONVEYOR is needed for removing the following:
·
DRIVE SHAFTS
·
CARRIAGE ASSEMBLY
·
DRIVE BELTS
1
. Do PROCEDURE "REMOVAL OF CONVEYOR".
2
. Cut the WIRE TIES along the upper TIERODS. Mark the position of the WIRE TIES.
See the top drawing on the next page.
3
. Take out the 4 NUTS at the TIERODS.
4
. Remove the 12 C-RINGS from the upper 2 TIERODS.
5
. Remove the CARRIAGE STOP.
6
. Slide out both upper TIERODS.
KODAK AG, Stuttgart 2-47
SM 3058-6
9/98