Kodak X-Omat MULTILOADER 300 Plus Service Manual page 14

SM 3058-6
4
. Take out the 2 MOUNTING SCREWS of the GUIDE BRACKET.
5
. Remove the NUT.
6
. Take off the GUIDE BRACKET.
7
. Take off the INPUT FLAP.
8
. Take out the 4 MOUNTING SCREWS of the MOTOR INPUT FLAP.
9
. Install the new MOTOR.
FUNCTION TEST
1
. Start the CASSETTE INPUT FLAP MOTOR M1
Start the SERVICE PROGRAM.
Select SERVICE MODE from the GLOBAL MENU ....................................... press ENTER
ENTER SERVICE MODE MESSAGE is displayed............................................ press ENTER
UNIT DATA are displayed ............................................................................... press ENTER
Select COMPONENT TEST from the MAIN MENU ....................................... press ENTER
Select CASSETTE MOTORS ............................................................................... press ENTER
Select INPUT FLAP MOT M1............................................................................. press ENTER
Select CLOSE/OPEN .......................................................................................... press ENTER
2
. Make sure that the MOTOR CAM turns clockwise. If it turns counter-clockwise
interchange PIN 1 and 3 at the MOTOR CONNECTOR.
3
. Exit the SERVICE PROGRAM
Press 3 times BACKSPACE.
Select LEAVE COMPONENT TEST ................................................................... press ENTER
Select QUIT ML300 SERVICE MODE ............................................................... press ENTER
Select Quit the program ................................................................................. press ENTER
9/98 2-2
REPLACEMENTS
KODAK AG, Stuttgart