Processor Interface Clutches - Kodak X-Omat MULTILOADER 300 Plus Service Manual

REPLACEMENTS
FUNCTION TEST.
1
. Check that the PROCESSOR INTERFACE MOTOR is running.
Start the SERVICE PROGRAM
Select SERVICE MODE from the GLOBAL MENU ....................................... press ENTER
ENTER SERVICE MODE MESSAGE is displayed............................................ press ENTER
UNIT DATA are displayed ................................................................................ press ENTER
Select COMPONENT TEST ................................................................................ press ENTER
Select INTERFACE/FILM MOT........................................................................... press ENTER
Select MAGAZINE ROLLER MOTOR M13 ...................................................... press ENTER
Select ON/OFF
2
. Exit the SERVICE PROGRAM
Press 3 times BACKSPACE
Select LEAVE COMPONENT TEST .................................................................. press ENTER
Select QUIT ML300 SERVICE MODE ............................................................... press ENTER
Select Quit the program ................................................................................. press ENTER.

PROCESSOR INTERFACE CLUTCHES

There are 2 free running ONE_WAY CLUTCHES in the PROCESSOR INTERFACE PULLEYS.
If you pull a FILM through the PROCESSOR INTERFACE in direction of the PROCESSOR
the toothed BELT must not move. If it moves as you pull, one of the free running ONE-WAY
CLUTCHES is assembled wrong.
This ARROW must be on the visible side of the
CLUTCH and must point into the indicated direction. It
is possible that the ARROW is covered by the C-RING
KODAK AG, Stuttgart
figure 2-40
2-43
SM 3058-6
9/98