Magazine Unit; Tilt Position - Kodak X-Omat MULTILOADER 300 Plus Service Manual

SM 3058-6
Select CHANGE ML300 DATA from the MAIN MENU ............................... press ENTER
Select CHANGE PARAMETER .......................................................................... press ENTER
Select DISABLE INTERF ...................................................................................... press ENTER
Key in AA............................................................................................................. press ENTER
Select STORE PARAMETER ............................................................................... press ENTER
2
. Exit the SERVICE PROGRAM.
Press BACKSPACE twice
Select QUIT ML300 SERVICE MODE ............................................................... press ENTER
Select Quit the program ................................................................................. press ENTER

MAGAZINE UNIT

TILT POSITION

PURPOSE:
To separate the FILMS in the MAGAZINE.
This PARAMETER gives the distance in steps, the FILM POCKET SUCKER BAR has to
move up from the top of the FILM STACK after an unexposed FILM was picked up. After the
TILT POSITION is reached, the FILM POCKET SUCKER BAR is tilted back. This separates
the top FILM from the remaining FILMS in the MAGAZINE.
1 increment = 0.09mm
RANGE:
DEFAULT:
1
. Change the PARAMETER TILT POSITION.
Start the SERVICE PROGRAM
Select SERVICE MODE from the GLOBAL MENU ....................................... press ENTER
ENTER SERVICE MODE MESSAGE is displayed............................................ press ENTER
UNIT DATA are displayed ................................................................................ press ENTER
Select CHANGE ML300 DATA from the MAIN MENU ............................... press ENTER
Select CHANGE PARAMETER .......................................................................... press ENTER
Select TILT POSITION ......................................................................................... press ENTER
Key in the new value....................................................................................... press ENTER
Select STORE PARAMETER ............................................................................... press ENTER
2
. Exit the SERVICE PROGRAM.
Press BACKSPACE twice
Select QUIT ML300 SERVICE MODE ............................................................... press ENTER
Select Quit the program ................................................................................. press ENTER
9/98
0h...46h
14h
4-6
PARAMETER
KODAK AG, Stuttgart