PARAMETER
ADDITIONAL STEPS
PURPOSE:
To achieve good contact between MAGAZINE SUCKERS and the top FILM in the
MAGAZINE. This PARAMETER gives the number of additional steps after the FILM PIN
reached the top FILM in the MAGAZINE. This ensures that the SUCKERS are in close
contact with the top FILM.
Note
If too many ADDITIONAL STEPS are used PRESSURE MARKS on the FILM may show up.
1 increment = 0.09mm
RANGE:
DEFAULT:
1
.
Change the PARAMETER ADDITIONAL STEPS.
Start the SERVICE PROGRAM
Select SERVICE MODE from the GLOBAL MENU ....................................... press ENTER
ENTER SERVICE MODE MESSAGE is displayed............................................ press ENTER
UNIT DATA are displayed ................................................................................ press ENTER
Select CHANGE ML300 DATA from the MAIN MENU ............................... press ENTER
Select CHANGE PARAMETER .......................................................................... press ENTER
Select ADDITIONAL STEPS ................................................................................ press ENTER
Key in the new value....................................................................................... press ENTER
Select STORE PARAMETER ............................................................................... press ENTER
2
.
Exit the SERVICE PROGRAM.
Press BACKSPACE twice
Select QUIT ML300 SERVICE MODE ............................................................... press ENTER
Select Quit the program ................................................................................. press ENTER
LOWER POCKET
PURPOSE:
To place the unexposed FILM correctly into the CASSETTE.
Additional down-steps for the FILM POCKET SUCKER BAR into the CASSETTE. It prevents
the unexposed FILM from floating out of the CASSETTE.
Note
In the OPERATING SOFTWARE VERSION 3.0, this PARAMETER is ignored for VIDEO FILM
HOLDERS.
1 increment = 0.09mm
RANGE:
DEFAULT:
KODAK AG, Stuttgart
0h...1Eh
0Ah
0h...64h
34h
4-7
SM 3058-6
9/98