Kodak X-Omat MULTILOADER 300 Plus Service Manual page 20

SM 3058-6
6
. Take off the DOWEL PIN and the BEARING.
DOWEL PIN
7
. Take off the left side DRIVE BELT.
8
. Take off the C-RING, WASHER and the DOWEL PIN of the PLASTIC DRIVE
PULLEY.
9
. Take off the TRANSPORT ROLLER DRIVE BELT on the right side.
10
. Remove the right-hand CENTRING BAR from the MOUNTING BRACKET. To do
so take out the 2 MOUNTING SCREWS and lift up the right-hand TRANSPORT
ROLLERS with their BEARING SIDE.
11
. Take off the right-hand PLASTIC PULLEY and BEARING of the TRANSPORT
ROLLER.
12.
Shift the TRANSPORT ROLLER fully to the left until it stops.
13
. Lift the right end of the TRANSPORT ROLLER up and slide it out to the right.
14
. Install new the TRANSPORT ROLLER.
9/98
BEARING
figure 2-8
2-8
REPLACEMENTS
DOWEL PIN
BEARING
C-RING
PLASTIC DRIVE
PULLEY
SMALL DRIVE PULLEY
KODAK AG, Stuttgart