Kodak X-Omat MULTILOADER 300 Plus Service Manual page 120

SM 3058-6
Note
It is most important that SCREW 1 is tightened. If it is not tight, the relationship between the
2 FILM POCKET TIMING DISKS and the MAGAZINE SUCKER BAR will be lost. It is then
impossible to pick up a film from the MAGAZINE.
57.
Tighten SCREW 1
58.
Move the COLLAR with SCREW 2 to the left as far as possible and tighten
SCREW 2. See figure 3-48.
Note
Do not tighten the LENGTH ADJUSTMENT SCREWS too much, otherwise they dig into the
BLOWPIPES and a fine adjustment is no longer possible.
59.
Check that the BLOWPIPES are correct in the MAGAZINE RECESSES. The
BLOWPIPES must not be in the shaded areas. They have to be between the centreline
of the recess and the MAGAZINE WALL. They must not touch the MAGAZINE WALLS.
If this distance is not correct, loosen the LENGTH ADJUSTMENT SCREWS of the
BLOWPIPES and shift them forward or backward. Tighten the screws.
LENGTH
ADJUSTMENT
SCREW
9/98
figure 3-49
3-50
ADJUSTMENTS
Centreline of RECESS
LENGTH
ADJUSTMENT
SCREW
KODAK AG, Stuttgart