Kodak X-Omat MULTILOADER 300 Plus Service Manual page 122

SM 3058-6
63.
Check that the 0.5mm HOLE (Slit before MOD 20) of the BLOWPIPES (Parts of
MOD 20) is just above the BLOWPIPE POSITIONER.
Note
The position of the hole in the BLOWPIPES is important to separate the films in the
MAGAZINES.
64.
If the position of the HOLE is not correct, loosen the HEIGHT ADJUSTMENT
SCREWS of the BLOWPIPES and move the BLOWPIPES up or down as required.
Then fasten the SCREWS.
65.
Switch off the SOLENOID Y14.
Select SOLENOID OFF
66.
Remove the BLOW PIPE POSITIONER TOOL from the SUCKERS. The TOOL can
only be taken off, after SOLENOID VALVE Y12 is switched off and air is blown into
the SUCKERS.
Press BACKSPACE twice to come back to the screen COMPONENT TEST
Select SOLENOID VALVES................................................................................ press ENTER
Select MAGAZINE SUCKING Y12.................................................................... press ENTER
Select SOL. VALVE OFF
Press BACKSPACE
Select MAGAZINE BLOW SUCKER Y10 .......................................................... press ENTER
Select SOL. VALVE ON
Select SOL. VALVE OFF
Press BACKSPACE twice to come back to the screen COMPONENT TEST
Select MAGAZINE MOTORS ............................................................................ press ENTER
Select COMPRESSOR M16 ............................................................................... Press ENTER
Select MOTOR OFF
9/98
BLOW PIPE HOLE
HEIGHT ADJUST-
TL 4582
MENT SCREW
figure 3-51
3-52
ADJUSTMENTS
KODAK AG, Stuttgart