Kodak X-Omat MULTILOADER 300 Plus Service Manual page 163

ADJUSTMENTS
EXIT ROLLERS
10.
Repeat step 9 with the FILM at the right-hand side. If there is no signal from
SENSOR B25, loosen its MOUNTING SCREWS and move the SENSOR up or down as
required. Fasten the MOUNTING SCREWS.
11.
Repeat step 9 with the FILM at the left-hand side. If there is no signal from
SENSOR B26, loosen its MOUNTING SCREWS and move the SENSOR up or down as
required. Fasten the MOUNTING SCREWS.
12.
If you had to change the position of a SENSOR in step 10 or 11, go back to step 7.
13.
Exit the SERVICE PROGRAM and disconnect the LAP TOP COMPUTER.
14.
Mount the PROCESSOR INTERFACE and the REAR PANEL in place.
FINAL TEST
1
. Run a few test cycles with different cassette sizes.
KODAK AG, Stuttgart
SENSOR
figure 3-82
3-93
SM 3058-6
MOUNTING SCREW (2)
9/98