Kodak X-Omat MULTILOADER 300 Plus Service Manual page 150

SM 3058-6
4
. Start the INTERFACE FLAP MOTOR M11.
Start the SERVICE PROGRAM
Select SERVICE MODE from the GLOBAL MENU ....................................... press ENTER
ENTER SERVICE MODE MESSAGE is displayed............................................ press ENTER
UNIT DATA are displayed ................................................................................ press ENTER
Select COMPONENT TEST ................................................................................ press ENTER
Select INTERFACE/FILM MOT. ......................................................................... press ENTER
Select INTERFACE FLAP MOTOR M11 ........................................................... press ENTER
Select MOTOR ON
5
. While the CAM is turning, make sure that the SIDE PLATE is moving only slightly
when the CAM is touching the INTERFACE FLAP BRACKET. If the BRACKET moves
too much proceed with step 6 else proceed with step 10.
6
. Stop MOTOR M11.
Select MOTOR OFF
7
. Reposition the MOTOR ASSEMBLY.
8
. Start MOTOR M11.
Select MOTOR ON
9
. Check once more that the SIDE PLATE is moving only slightly when the CAM is
touching the INTERFACE FLAP BRACKET
10.
Stop MOTOR M11.
Select MOTOR OFF
Part 2. SENSOR B 33
Purpose:
The INTERFACE FLAP MOTOR should stop when the INTERFACE FLAP is closed. This is
basically correct. However, especially when operated with 60 Hz the INTERFACE FLAP
MOTOR M11 does not stop immediately and the SENSOR B33/M_PI_F may by released. If
now the next CASSETTE is unloaded, the CASSETTE TASK believes that the INTERFACE
FLAP is already open. In this case the FLAP is not opened and the FILM falls into the area
of the FILM POCKET. To avoid this failure, adjust SENSOR B 33 so that the MOTOR M11 is
stopped reliably, before the CAM reaches the lowest position.
1. Start MOTOR M11.
Select MOTOR ON
9/98 3-80
ADJUSTMENTS
KODAK AG, Stuttgart