Interface Flap Cam And Sensor B33 - Kodak X-Omat MULTILOADER 300 Plus Service Manual

ADJUSTMENTS

INTERFACE FLAP CAM and SENSOR B33

Purpose:
The INTERFACE FLAP MOTOR should stop when the INTERFACE FLAP is closed.
SENSOR B33/M_PI_F
MOUNTING
SCREWS
SIDE PLATE
PART 1. INTERFACE FLAP CAM
1
. Rotate out the FILM CHUTE.
2
. Turn the CAM clockwise by hand until the lowest point of the CAM rides on the
INTERFACE FLAP BRACKET.
3
. Make sure that the distance between the plush and the INTERFACE FLAP is not
more than 2 mm. If necessary, move the MOTOR ASSEMBLY down or up after
loosening the MOUNTING SCREWS.
KODAK AG, Stuttgart
MOTOR ASSEMBLY
lowest point of CAM
figure 3-69
3-79
SM 3058-6
MOTOR M11
CAM
INTERFACE FLAP BRACKET
9/98