Changing The Film Sensors - Kodak X-Omat M43 PROCESSOR Service Manual

Changing the FILM SENSORS

Warning
Use ESD precautions.
[1] Check that:
• PROCESSOR is de-energized
• main power is disconnected
[2] Remove the FEED TRAY by removing:
• 2 SCREWS
• 2 WASHERS
• 2 LOCK WASHERS
Removing the FEED TRAY
Figure 82
[3] Remove:
• DRAIN VALVE KNOBS by removing the 2 SETSCREWS
• DRYER TEMPERATURE CONTROL KNOB
• FRONT ACCESS PANEL by loosening the 2 SCREWS
• DRIVE SIDE ACCESS PANEL by loosening the 2 SCREWS
[4] See Figure 84 on Page 95. From the FILM SENSOR BAR remove:
• 2 SCREWS
• 2 LOCK WASHERS
• 2 WASHERS
[5] Cut the WIRE TIES as necessary to disconnect the CONNECTORS. Note the position of the WIRE TIES for
later installation.
[6] Disconnect:
• CONNECTOR P/J14 for FILM SENSOR U7 (left side of FEED TRAY)
• CONNECTOR P/J15 for FILM SENSOR U8 (center of FEED TRAY)
• CONNECTOR P/J16 for FILM SENSOR U9 (right side of FEED TRAY)
981090 – September 1995
SCREW (2)
LOCK WASHER (2)
WASHER (2)
FEED TRAY
Electrical
H130_0084BCA
H130_0084BA
93