Checking Miscellaneous Components; Checking The Display Panel; Checking The Transport - Kodak X-Omat 5000 RA PROCESSOR Installation Instructions Manual

Hide thumbs Also See for X-Omat 5000 RA PROCESSOR:

Table of Contents

INSTALLATION INSTRUCTIONS

Checking Miscellaneous Components

[1] Check that the following components operate:

(a) DRYER BLOWER and HEATER

(b) WATER SUPPLY SOLENOID — Listen for the sound of water entering the PROCESSOR.

[1] Check that the green "Ready" light on the DISPLAY PANEL illuminates after the PROCESSOR has been

allowed to warm-up for approximately 15 minutes at 26°C (72°F) ambient conditions and 26°C (72°F) water

temperature.

[2] Check that the DEVELOPER temperature illuminated on the DISPLAY PANEL is in the operating range

between 35° and 38.3°C (95° and 101°F).

Feed one sheet of processed 35 x 43 cm (14 x 17 in.) film into the PROCESSOR to check that the transport system

and the REPLENISHMENT PUMPS operate correctly.

January 1996 – 5B6339

Table of Contents