Paper Jam In Finisher Section - Toshiba e-STUDIO281c Service Handbook

Multifunctional digital color systems

Hide thumbs Also See for e-STUDIO281c:

Table of Contents

[ 2 ] Paper jam in finisher section

[EA10] Paper transport delay jam

Is there any paper remaining on the transport path in the finisher or equipment?

Is the connector J10 on the finisher controller PC board disconnected?

Is the harness connecting the finisher controller PC board and inlet sensor (S2) open cir-

Is the inlet sensor working normally? (Check the movement of the actuator.)

Replace the finisher controller PC board.

MJ-1023/1024

Is there any paper remaining on the transport path in the finisher or equipment?

Is the connector J708 on the finisher controller PC board disconnected?

Is the harness connecting the finisher controller PC board and inlet sensor (PI33) open cir-

Is the inlet sensor working properly? (Check the movement of the actuator.)

Replace the finisher controller PC board.

e-STUDIO281c/351c/451c

TROUBLESHOOTING

Remove the paper.

Connect the connector securely. Replace the harness.

1) Connect the connector of the inlet sensor securely.

2) Attach the actuator securely if its shaft is out of place.

3) Replace the inlet sensor.