Suzuki Wagon R Manual page 170

LOCK
UNLOCK
4) Install ignition switch assembly and immobilizer control module
to steering column.
5) Install ignition switch cylinder assembly as follows.
a) Push steering lock (2) down till it clicks, using screw driver
(1), so that it is at unlock position.
b) Turn ignition key of ignition switch cylinder assembly to
"ACC" position.
c) In this state, push ignition switch cylinder assembly into
steering column till it clicks.
6) Install turn & dimmer switch, wiper switch and ignition switch
protector to steering column.
7) Connect all connectors that have been removed in "Removal".
8) Install contact coil cable assembly and steering wheel.
Refer to CONTACT COIL CABLE ASSEMBLY and STEERING
WHEEL in this section.
9) Connect negative battery cable.
10) Enable air bag system. Refer to "Enabling Air Bag System" un-
der "Precautions" earlier in this section.
STEERING LOWER SHAFT
REMOVAL
1) Turn steering wheel so that vehicle's front tires are at straight-
ahead position.
2) Turn ignition switch to "LOCK" position and remove key.
CAUTION:
Never turn steering wheel while steering lower shaft is re-
moved.
Should it have been turned and contact coil have got out
of its centered position, it needs to be centered again.
Also, turning steering wheel more than about two and a
half turns will break contact coil.
3) Remove steering joint cover.
STEERING WHEEL AND COLUMN 3C-17