Suzuki Wagon R Manual page 177

3D-4 FRONT SUSPENSION
Cannot be separated
"a"
SUSPENSION CONTROL ARM/KNUCKLE
CHECK
Inspect control arm/knuckle for cracks, deformation or damage.
Inspect control arm bushing for damage, wear or deterioration.
SUSPENSION CONTROL ARM JOINT CHECK
1) Check for smooth rotation.
2) Inspect ball stud for damage.
3) Inspect dust cover for damage.
4) Inspect for play in ball joint. If found defective, replace.
NOTE:
Suspension arm and arm joint cannot be separated.
If there is any damage to either, control arm assembly must be re-
placed as a complete unit.
WHEEL DISC, NUT & BEARING CHECK
1) Inspect each wheel disc for dents, distortion and cracks. A disc
in badly damaged condition must be replaced.
2) Check wheel nuts for tightness and, as necessary retighten
them to specification.
Tightening Torque
.
(a): 85 N m (8.5 kg-m, 61.5 lb-ft)
3) By rotating wheel actually, check wheel bearing for noise and
smooth rotation. If defective, replace bearing.
4) Check wheel bearing for wear. When measuring thrust play,
a) Remove wheel.
b) Fix brake disc tightening wheel nuts.
c) Set a dial gauge.
d) Check wheel bearing for thrust play.
Thrust play limit "a": 0.1 mm (0.004 in.)
When measurement exceeds limit, replace bearing.