Suzuki Wagon R Manual page 227

4-6 FRONT DRIVE SHAFT
A:
B:
A:
B:
4) Remove spider (1) by using 3 arms puller (2).
CAUTION:
To prevent needle bearing of joint from being degreased,
do not wash it if it is to be reused.
5) Remove boot small band, then pull out differential side boot from
shaft.
6) Pull out damper through shaft. (For M/T model only)
7) Remove wheel side boot big band (1) as follows.
A: For boot big band without joint
a) Cut boot big band using a iron saw or a nipper with care
not to damage wheel side joint housing.
B: For boot big band with joint
a) Draw hooks of boot big band together and remove band.
8) Remove wheel side small band, then pull out wheel side boot
from shaft.
For DOJ type drive shaft (left side)
CAUTION:
Disassembly of wheel side joint is not allowed. If noise or
damage exists in it, replace it as assembly.
1) Remove differential side boot big band (1) as follows.
A: For boot big band without joint
a) Remove boot big band by tapping boot and band with
plastic hammer.
If it is hard to remove boot big band, cut it using a nipper
or a iron saw with care not to damage DOJ housing.
B: For boot big band with joint
a) Draw hooks of boot big band together and remove band.