Suzuki Wagon R Manual page 243

5-8 BRAKES
4) When fluid pressure in the cylinder is almost depleted, retigh-
ten bleeder plug.
5) Repeat this operation until there are no more air bubbles in hy-
draulic line.
6) When bubbles stop, with depressing brake pedal, tighten
bleeder plug.
Tightening Torque
.
(b): 8.5 N m (0.85 kg-m, 6.5 lb-ft)
.
6.5 N m (0.65 kg-m, 5.0 lb-ft)
7) Then attach bleeder plug cap.
8) After completing bleeding operation, apply fluid pressure to
pipe line and check for leakage.
9) Replenish fluid into reservoir up to specified level.
10) Check brake pedal for "sponginess". If found spongy, repeat
entire procedure of bleeding.
. . . . . . for rear brake
. . . . . . for front brake