Suzuki Wagon R Manual page 233

4-12 FRONT DRIVE SHAFT
D When installing left oil seal (1) and right oil seal (2), use care so
that oil seals in proper direction and position as shown figure.
Distance "a": 11 – 12 mm (0.43 – 0.47 in.)
"b": 2 – 3 mm (0.08 – 0.12 in.)
D Be sure to apply grease to oil seal lip and bearing side space indi-
cated in figure.
"A": Grease 99000-25010
D Press-fit center shaft (1) from left oil seal side.
INSTALLATION
CAUTION:
D To avoid excessive expansion of boot and consequential
disconnection of joint in boot, do not pull tripod joint
housing.
D Protect oil seals and boots from any damage, preventing
them from unnecessary contact while installing drive
shaft.
D Do not hit joint boot with hammer. Inserting joint only by
hands is allowed.
D Make sure that differential side joint is inserted fully and
its snap ring is seated as it was.
Install drive shaft assembly by reversing removal procedure and
noting the following points.
D Install wheel side joint to steering knuckle first and then differen-
tial side joint to transmission or center shaft.
D Tighten each bolt and nut to the specified torque.
Refer to figure of the beginning of ON-VEHICLE SERVICE for
specified tightening torque.
D Apply sealant to drain plug for manual transmission.
D Fill transmission with oil as specified. (Refer to SECTION 7A.)
D For automatic transmission, carry out full step of fluid level check
procedure i.e. LEVEL CHECK, referring to Section 7B.
D Check toe seating and adjust as required.