Suzuki Wagon R Manual page 266

INSTALLATION
NOTE:
Check for push rod length referring to above BRAKE BOOST-
ER INSPECTION.
3, "A"
1) Install new gasket and booster to dash panel as shown. Then
connect booster push rod clevis (1) to pedal arm (2) with clevis
pin (3) and clip (4).
"A": Grease A 99000-25010
2) Tighten booster attaching nuts to the specified torque.
Tightening Torque
(a): 13 N
3) Connect brake vacuum hose to brake booster.
4) Install master cylinder, referring to steps 3) to 8) of its INSTALLA-
TION of this section.
5) After installing, perform BOOSTER OPERATION CHECK refer-
ring to SECTION 5.
BRAKES PIPE / HOSE / MASTER CYLINDER 5A-13
.
m (1.3 kg-m, 9.5 lb-ft)