5A-6 BRAKES PIPE / HOSE / MASTER CYLINDER
REAR BRAKE HOSE/PIPE
REMOVAL
1) Raise and suitably support vehicle. Remove tire and wheel.
2) Clean dirt and foreign material from both hose end or pipe end fittings. Remove brake hose or pipe.
INSTALLATION
1) Reverse removal procedure for brake hose or pipe installation procedure.
D Install clamps properly referring to figure below.
D When installing hose, make sure that it has no twist or kink.
2) Fill and maintain brake fluid level in reservoir. Bleed brake system.
3) Perform brake test and check each installed part for fluid leakage.
[A]
[B]
Viewed from A
Top
Front
Right
Top
Top
Front
Right
[A]: with ABS
[B]: without ABS
a – h: Clamp
.
26 N
m (2.6 kg-m)
Top
Right
Front
Top
Front
1. 4 way joint
2. LSPV assembly
3. Rear brake hose
Top
Left
Top
Right
: Tightening Torque